Products > Test Equipment

Lower voltage for resistance measurement for FLuke 289

<< < (7/8) > >>

bdunham7:

--- Quote from: tonycstech on September 29, 2024, 12:39:53 am ---Otherwise its useless for modern electronics with multi phase controllers and processing units.
Maybe some tractor wiring or construction site measurements its best for FLUKE use but i dont see any use for it in my case. Maybe not this model.

--- End quote ---

I assure you people are using Fluke 289s on things other than tractors and construction.  Have you tried or are you willing to try any of the things I've suggested?

J-R:
https://youtu.be/YXeJ-BQnJtw?t=46

tonycstech:

--- Quote from: J-R on September 29, 2024, 02:03:34 am ---https://youtu.be/YXeJ-BQnJtw?t=46

--- End quote ---
Yep, there is a live demo for ya

J-R:

--- Quote from: tonycstech on September 29, 2024, 02:12:43 am ---
--- Quote from: J-R on September 29, 2024, 02:03:34 am ---https://youtu.be/YXeJ-BQnJtw?t=46

--- End quote ---
Yep, there is a live demo for ya

--- End quote ---
I guess there is no other way to say this, but even though you have mad repair skills, you probably need to hit the electronics books a bit...

tonycstech:

--- Quote from: J-R on September 29, 2024, 02:25:28 am ---
--- Quote from: tonycstech on September 29, 2024, 02:12:43 am ---
--- Quote from: J-R on September 29, 2024, 02:03:34 am ---https://youtu.be/YXeJ-BQnJtw?t=46

--- End quote ---
Yep, there is a live demo for ya

--- End quote ---
I guess there is no other way to say this, but even though you have mad repair skills, you probably need to hit the electronics books a bit...

--- End quote ---

All i need to know is if there is any way to hack the device internals so it would obey my will. I think firmware driven device can be hacked by altering the firmware.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod