Hi,
I was connecting probes from my shiny new Siglent SPD1168X power supply to drive a 3V COB LED. The connection wasn't great - I was pressing probes to the pads on the led board so it was intermittent. The Siglent would beep when I fiddled with the probes and started humming. I disconnected the probes and waited, and after a number of seconds of being left alone, the humming stopped accompanied by a final beep. I couldn't see any error message on the screen.
Any idea what the beeps mean? I couldn't find any mention in the manual, and even dug up the manual in Chinese (which I can't read) to see if I could discover any clues.
Thanks for any suggestions.
Cheers,
Josh