Products > Test Equipment

Measuring capacitance using UNIT UT139C

(1/1)

winkot:
When measuring capacitance up to 300 pF, the UNIT UT139C shows 0. In the range from 300 pF to 6800 pF, the device shows values, but with an error of 30-10%. And only after 0.01 µF does it show the correct values. Why is this happening ? This is normal?

Caliaxy:
Low capacity measurements are challenging on most multimeters... Are you measuring in relative mode?

winkot:
No, I don't use relative mode because the multimeter shows 0.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod