Products > Test Equipment
Micro Clip to scope probe connection
<< < (3/3)
joeqsmith:
Shown with an extension. 
luudee:

--- Quote from: joeqsmith on May 27, 2022, 01:07:40 am ---Shown with an extension.

--- End quote ---

Yes, I have used a similar setup in the past.  I was hoping for a better solution.

1. The large J clamp on the scope probe takes up to much space, so I avoid using that.
2. I would like to use that small plastic cap to cover up the ground ring to avoid accidental
    shorting/contact. But if I insert the plastic cap, the lengths of the pin is barely long enough
    for the small cable to grip on. It constantly comes off ...
3. The most important item, I would like the ground wire exit the probe at the same spot
    the signal wore dose, and allow me to attach a similar micro clip.

I think this part would be ideal:  PK1-5MM-112
(https://www.tme.eu/ae/en/details/lc-pk1-5mm-112/accessories-for-oscilloscopes-others/teledyne-lecroy/pk1-5mm-112/)
Need to find a more reasonably priced distributor ...


luudee






joeqsmith:

--- Quote from: luudee on May 27, 2022, 09:49:54 am ---3. The most important item, I would like the ground wire exit the probe at the same spot
    the signal wore dose, and allow me to attach a similar micro clip.

--- End quote ---

Normally when I get concerned about the signal, I'm probing direct.   For the typical 10X probe, I loop wire around the ground to get a smaller loop.   No reason you couldn't attach your two cables this way. 

 
hpw:

As mentioned, rounded pin's are usual used on digital connections.... Hantec / Siglent are rounded too!

My single old Tek click and now found here a colored bunch on Ali Clequee brand: https://www.aliexpress.com/item/4000985317660.html?spm=a2g0o.order_detail.0.0.18a4f19cvhYvQe

luudee:

Hi Guys,

just a quick update:

I was able to find the required connectors to make an adopter as I wanted.

These are the connectors I used.
https://www.aliexpress.com/item/1005002358582022.html
https://www.aliexpress.com/item/1005003208141862.html

Overall, I spent less than $10 USD for each adopter, and they appear to work just fine.

Pictures are better than words ... enjoy !

rudi

Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod