Products > Test Equipment

Micromaster LV48

<< < (4/7) > >>

giosif:
I don't actually know these things (parallel port and communication were a little before my time and never found the interest to try to understand them in detail), but I don't think whatever driver WinLV provides is something which will reflect in Windows Device Manager.
Instead, I think it's probably some sort of library that it installs (or overwrites an existing one?) as part of the application installation process.

That's my empirical understanding anyway...

coromonadalix:
v1 and v2

https://retro.m1ner.co.uk/ice-technology-winlv-programmer-software-2-0-0009/

Squarewave:
Ok, so next steps, try another cable.

Then before installing anything, I'll need to image this drive.

Thanks so far, hopefully we'll crack it!

coromonadalix:
normally  you have lpt modes like ecp spp ... as mentioned, normally  it should be ok in device manager,  unless Irq's are needed ???

if i read correctly  you have / use the motherboard lpt,  not an addon card

you have the basic  lpt configs in Bios :

LPT1: 0x378 (or occasionally 0x3BC) (IRQ 7)
LPT2: 0x278 (IRQ 6)
LPT3: 0x3BC (IRQ 5)

you should not have any errors in device manager  ...

and for the  winlv   it should ask the lpt port config / setting , unless it is hard coded to a specific adress ???

Squarewave:
Yes, I've tried all modes, even auto, IRQ is set to 7. There are no options in WinLV to alter port settings, so it must be embedded into the software?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod