Products > Test Equipment
Micromaster LV48
(1/7) > >>
Squarewave:
So I've got a Micromaster LV48 for the Boardmaster, work was getting shot of this also.

Here's what happens, when I connect it all up and power on, no power light. Keep it connected and powered up, restart the computer, the red power LED comes on for a few seconds then goes out. Start WinLV, the red LED comes on for a few seconds, then goes out, with the error message on the screen that the device isn't communicating.

Any thoughts? Thanks.
Squarewave:
Even a search for an operations manual draws a blank, can't find anything for this at all.......
giosif:

--- Quote from: Squarewave on August 29, 2024, 11:13:58 pm ---Here's what happens, when I connect it all up and power on, no power light. Keep it connected and powered up, restart the computer, the red power LED comes on for a few seconds then goes out. Start WinLV, the red LED comes on for a few seconds, then goes out, with the error message on the screen that the device isn't communicating.

--- End quote ---

I've got one such programmer and what you describe in terms of power LED turning on and off is generally normal behaviour: it is a power saving functionality of the programmer (the programmer supports powering from batteries).
This is mentioned in the presentation text in the attached documents (the only documentation I was able to find about the device).
With regards to the error message, the only thing I can think of is parallel port settings or compatibility issues.
Squarewave:
Thank you, will have a read and see where I get!  :D
Squarewave:
So I've taken a look at the port settings, but not really sure if anything here is right or even wrong.

Bios and Windows screen photos.....

Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod