Products > Test Equipment
Micromaster LV48
Squarewave:
So I've got a Micromaster LV48 for the Boardmaster, work was getting shot of this also.
Here's what happens, when I connect it all up and power on, no power light. Keep it connected and powered up, restart the computer, the red power LED comes on for a few seconds then goes out. Start WinLV, the red LED comes on for a few seconds, then goes out, with the error message on the screen that the device isn't communicating.
Any thoughts? Thanks.
Squarewave:
Even a search for an operations manual draws a blank, can't find anything for this at all.......
giosif:
--- Quote from: Squarewave on August 29, 2024, 11:13:58 pm ---Here's what happens, when I connect it all up and power on, no power light. Keep it connected and powered up, restart the computer, the red power LED comes on for a few seconds then goes out. Start WinLV, the red LED comes on for a few seconds, then goes out, with the error message on the screen that the device isn't communicating.
--- End quote ---
I've got one such programmer and what you describe in terms of power LED turning on and off is generally normal behaviour: it is a power saving functionality of the programmer (the programmer supports powering from batteries).
This is mentioned in the presentation text in the attached documents (the only documentation I was able to find about the device).
With regards to the error message, the only thing I can think of is parallel port settings or compatibility issues.
Squarewave:
Thank you, will have a read and see where I get! :D
Squarewave:
So I've taken a look at the port settings, but not really sure if anything here is right or even wrong.
Bios and Windows screen photos.....
Navigation
[0] Message Index
[#] Next page
Go to full version