Products > Test Equipment
Micsig CP1003/CP503 100MHz/50MHz Current Probe
Martin72:
--- Quote ---how to place the pictures so they open inline
--- End quote ---
One possibility is to use the default setting (end of post expendable thumbnail).
amar87:
Before i put the setup away i thought i would do some pulses through it and see what it does.
they say Delay < 30ns(6A ) i kind of get 2x this much. this delay should be the delay between the input current and the output voltage.
CH1 is the probe output.
CH2 is measuring the voltage from the signal generator.
Using the Skew Measurement and the cursors i get 69 nS.
Is that delay parameter from the datasheet something else or am i measuring something wrong?
amar87:
I made a mistake in the previous post i had that deskew delay set in one of the channels of the scope. the delay is 15 nS which is lower than 30 nS so well in spec...
Martin72:
Ah, very good.
Do you have access to a (very)fast risetime pulse ?
amar87:
what you see there in the rigol screenshot the 7 nS is the fastest i have......
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version