Products > Test Equipment

Micsig Current Probe CP2100A/B Tests and Comparing

<< < (42/42)

Tjuurko:

--- Quote from: Martin72 on December 08, 2024, 10:31:57 am ---Ah, I see that you only display the plot from 30khz and with 0.5dB scaling, so it looks a bit wild.
Use the scaling I used and the plots should be almost identical (except for the phases).
--- End quote ---
From DC to 100 kHz there is nothing interesting.
I wanted to see how much it is possible to compensate for the phase error using a delay of 153 ns.

tautech:

--- Quote from: Tjuurko on December 12, 2024, 10:27:55 am ---
--- Quote from: Martin72 on December 08, 2024, 10:31:57 am ---Ah, I see that you only display the plot from 30khz and with 0.5dB scaling, so it looks a bit wild.
Use the scaling I used and the plots should be almost identical (except for the phases).
--- End quote ---
From DC to 100 kHz there is nothing interesting.
I wanted to see how much it is possible to compensate for the phase error using a delay of 153 ns.

--- End quote ---
Channel Skew max values should be in your scopes datasheet.  :popcorn:

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod