Products > Test Equipment
Micsig dp10007 or dp750-100 differential probe
<< < (4/4)
H.O:
This is not something that gets used very often here. When I have used it it's been on RS485 and CAN bus stuff so <10V and the issue with the trace offset moving around when you touch/move the connector bothers me ever so slightly, it does subtract from the otherwise very nice look and feel of the probe. Remember that when it comes to differential high(ish) voltage probes this one is cheap.

I have not done any sort of CCMR tests or anything.
Randy222:
Is the 75-100 good enough to do FFT analysis on US mains power (120-230vac rms 60Hz)? Or would it itself introduce too much noise?

Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod