Products > Test Equipment

Micsig new oscilloscopes on website

<< < (14/15) > >>

skander36:
I would make pressure on seller for this. They should exchange probes with the good ones.
Is about a Micsig scope with Micsig probes.
There is no room for tolerance here.

dmeek:
To follow up on this. I contacted Micsig and they said the probes needed to be re-programmed. They arranged pick-up and paid shipping. I have them back now, working.
I found Micsig responsive and helpful. It was a little bit of trouble but all is OK now.

Fungus:

--- Quote from: dmeek on May 29, 2023, 06:38:46 pm ---I found Micsig responsive and helpful.
--- End quote ---

Yep. Micsig answer emails very promptly and make an effort to fix things.

(in the two times I've dealt with them, at least, and other people have said the same)

scoper007:

--- Quote from: skander36 on April 03, 2023, 03:21:01 pm ---I don't have active probes to test, but as you say X10 probes are detected.
I also opened mine to see If I can do something about fan.
Seem to be identical with the 2004.
I don't know what can be improved on the fan, other than finding a better quality one.
I'm afraid to modify speed as in this case the calibration cannot be guaranteed.
It runs quite hot without fans and shields.

--- End quote ---
Well, happened to asked one of Micsig's domestic sales, says they are optimizing the TO2004/3004 software and probably a new hardware.

skander36:

--- Quote from: scoper007 on June 28, 2023, 07:12:18 am ---
--- Quote from: skander36 on April 03, 2023, 03:21:01 pm ---I don't have active probes to test, but as you say X10 probes are detected.
I also opened mine to see If I can do something about fan.
Seem to be identical with the 2004.
I don't know what can be improved on the fan, other than finding a better quality one.
I'm afraid to modify speed as in this case the calibration cannot be guaranteed.
It runs quite hot without fans and shields.

--- End quote ---
Well, happened to asked one of Micsig's domestic sales, says they are optimizing the TO2004/3004 software and probably a new hardware.

--- End quote ---

And how can this "probably" help with my problem?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod