| Products > Test Equipment |
| Micsig Tablet Oscilloscope tBook mini TO1104 review (100Mhz 4 channel 'scope) |
| << < (22/37) > >> |
| pmcouto:
The wait is over! New software version with serial decoders is now available from Micsig. :-+ Upgrade can be performed directly from the scope – it downloads the software and installs it automatically. Now, let’s see how much Micsig will charge for this new options. |
| nctnico:
I just upgraded which was pretty painless using a network connection. I have not tested protocol decoding yet but the definitive list of protocols seems to be: UART, LIN, CAN, SPI, I2C, Arinc 429 and 1553B (the latter two are avionics protocols) One of the things that seems to be fixed is the sensitivity of the buttons on the side of the screen (run/stop, single seq, etc). On my unit they work fine now :-+. I played a bit with UART decoding but unfortunately it seems it only decodes what is on screen. As soon as a character is scrolled partly outside the screen it changes into a ? mark :-- Also no event list so all in all the decoding still needs work. |
| paul_ius:
oh man, I was hoping to jump on the beta testers' train or that the feature was going to be included by default in the official update. |
| exe:
--- Quote from: paul_ius on July 29, 2017, 01:55:03 pm ---oh man, I was hoping to jump on the beta testers' train or that the feature was going to be included by default in the official update. --- End quote --- Well, I have serial decoding options enabled (at least it shows the menu), but I haven't activated my serial decoding key yet. So, it might work for everyone. Fingers crossed! BTW, guys, it looks like the latest firmware solved my issue with the scope switching on on power loss. I'm yet to fully test this, but it looks like it wakes up when supply is on (shows stupid battery animation) or off (just shows micsig logo), but then it switches off again (or is it a deep sleep or something?). |
| paul_ius:
--- Quote from: exe on July 29, 2017, 05:17:36 pm ---Well, I have serial decoding options enabled (at least it shows the menu), but I haven't activated my serial decoding key yet. So, it might work for everyone. Fingers crossed! --- End quote --- I have the menu as well and it lets me to activate it, but when I try to read the data I can't see the decoder line anywhere. |
| Navigation |
| Message Index |
| Next page |
| Previous page |