Products > Test Equipment
Micsig Tablet Oscilloscope tBook mini TO1104 review (100Mhz 4 channel 'scope)
BravoV:
--- Quote from: nctnico on April 28, 2017, 05:37:17 pm ---Another Micsig TO1104 (tBook mini) review
--- End quote ---
Thank you so much ! Really nice and concise review. :-+
Its your fault, now its in my wish list. >:D
Imho, you should make a new thread for it, instead of buried in here.
BravoV:
--- Quote from: mikeselectricstuff on April 28, 2017, 05:57:00 pm ---
--- Quote ---It all started a couple of weeks ago when I was contacted by Micsig's technical support and they asked me if I was interested in writing a review of the tBook mini (TO1000) series and they would offer a discount in exchange.
--- End quote ---
Only a discount..? A comprehensive review like this should at least get a freebie!
--- End quote ---
+1 , to be honest Mike, your review video didn't make me wanting it, but nctnico's does.
nctnico:
--- Quote from: BravoV on April 28, 2017, 06:06:26 pm ---Imho, you should make a new thread for it, instead of buried in here.
--- End quote ---
I thought about that but decided against it in order not to get too many different threads about the same instrument.
nctnico:
I think there is something odd about the decoding in the TO1104. Look at this picture which didn't make the cut for the review:
The samplerate is 400ks/s and yet it can decode a 500kbit/s CAN stream (judging from the correct message checksum). :wtf: It is almost as if the decoding is a seperate system using a higher samplerate. Once the decoding is released officially I definitely want to dig deeper into it.
mikeselectricstuff:
--- Quote from: nctnico on April 29, 2017, 10:50:38 am ---I think there is something odd about the decoding in the TO1104. Look at this picture which didn't make the cut for the review:
The samplerate is 400ks/s and yet it can decode a 500kbit/s CAN stream (judging from the correct message checksum). :wtf: It is almost as if the decoding is a seperate system using a higher samplerate. Once the decoding is released officially I definitely want to dig deeper into it.
--- End quote ---
Could be the decode engine has its own clock, and uses the digital trigger pathway maybe 3-4x baud for uart, SCLK for SPI.
See if you can set different thhresholds for trigger and decode on the same channel.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version