Products > Test Equipment
MS05000 Budget Logic Analyzer Probe Set Design
Gandalf_Sr:
I just posted a SET to France, I wonder how long that will take? International shipping has become a joke these days.
Gandalf_Sr:
A member has contacted me about a SET of boards that he wants to adapt to an MSO1000Z like an RPL116. I went back and looked at this thread but it's not clear to me whether the output of my chips will drive into an MSO1000Z, will it? Do I need terminating resistors?
He's talking about using a ribbon cable to adapt from my setup but the neatest solution would be for me to create a variation of the connector PCB. Anyone interested in that?
cstereo:
PCB posted in the US on September 9th and received today in France after only 1 week !
Thank you again for your time.
Gandalf_Sr:
--- Quote from: cstereo on September 16, 2020, 08:37:29 pm ---PCB posted in the US on September 9th and received today in France after only 1 week !
Thank you again for your time.
--- End quote ---
You are welcome, hope they work out well for you.
mtnzap73:
I am late to the party, but have a soldering question.
I read all I could find in the threads above re flux, soldering advice.
But, I did not see anything about using solder paste, and an air solder station.
They are not too expensive, and are made for SM obviously.
It even seems that DK's price for an Aoyue 852 is well less than Amazon.
Isn't this a fine justification for another cool tool? Just slip it into the DK order ...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version