Products > Test Equipment

MSO2000 Application module hack

<< < (24/24)

PA0PBZ:

--- Quote from: Le_Bassiste on May 28, 2016, 09:56:24 am ---VGA output works, but can't do any scaling, so it's basically useless anyway. :--

--- End quote ---

Meh, that should be a job for the monitor.

luisprata:
My frequencies are the half of yours.  15.734kHz / 30Hz.  Could you measure Y400 frequency oscillator? Thank you again.

Update: My Y400 frequency is 25.175MHz.

Update: I think maybe your monitor shows the frequency of the VGA mode used, not actual signals. Could you confirm that?

aibi1590:
Hey I got one mso2012 and a white screen appears.
I watch the ubootlog and stop at DRAM:64MB
I infer that the flash is faulty.
Is it still possible to repair this?

Krikke944:
If you still have a copy of the patched FW 1.56 I would like to try it out.

Minsoon:
Hi.~
I purchased mso2014 used only yesterday.
There is no logic probe option, so I plan to create this using artwork.
I received good help from eevblog about the Agilent 54831 hack before.
As expected, mso2014 information is also available here.
I upgraded to the latest version 1.56 today.

The serial port on the rear Side will also need to be made using a PCB.
Can I ask for the patched firmware for App-Module Hack?
thank you!.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod