| Products > Test Equipment |
| MSO2000 Application module hack |
| << < (15/24) > >> |
| Edison517:
I wrote a quick program for Arduino that will program the 24LC08 chip to any of the 3 possible combinations. Just hook up the I2C lines and power & ground and run the program :) http://pastebin.com/raw/AMZRxq3T |
| luisprata:
After some work, I`ve removed password for root, accessed command line and went into dir /usr/share/tek where i found "fw_setenv" and executed: ./fw_setenv model "MSO2024" After that, my oscilloscope thinks it is MSO2024. I think it could be possible just changing fwEnvUpdate.sh. So you have to mount firmware.img, change fwEnvUpdate.sh, change md5sum.txt with new md5 for fwEnvUpdate.sh, umount and that`s it. To change the file, put before last line of fwEnvUpdate.sh: $FW_SETENV model "MSO2024" echo "Finished updating environment variables." Besides showing MSO2024 I can't test performance after modification. If someone tested, please tell us. Sorry about bad english. Thanks. |
| DiodomanX:
I found this https://github.com/dmitrodem/tek_softhack, and install the modified firmware in my DPO2012B and all modules was unlocked, but i have an issue, without the modified firmware autoset take 2-3 seconds to work with 1M point record, with the modified firmware it takes about 5 and a half second, any one with hardware module can check this. Same for math functions, and i dont know if affect the decode of buses. Can someone confirm, i can share my update image. Enviado desde mi XT1563 mediante Tapatalk |
| luisprata:
DiodomanX, Thank you for the tip for software unlock. About autoset, I measured the time and it is about 3.8s with 1 channel enabled and probing 1kHz compensation signal. With or without hardware keys. But when I enable all 4 channel the time rises to 7s. Luis AP Barbosa. |
| DiodomanX:
Then it is normal that time is increased, some progress in testing to increase the bandwidth? Enviado desde mi XT1563 mediante Tapatalk |
| Navigation |
| Message Index |
| Next page |
| Previous page |