Products > Test Equipment
MSO2000 Application module hack
<< < (16/24) > >>
DiodomanX:
I will do it this weekend, can you tell me wich ic i have to search.

Enviado desde mi XT1563 mediante Tapatalk

luisprata:
To check if you have a CPLD take a look at this video (10min10sec). It's an altera MAX II.


About bandwidth upgrade, my earlier tests were wrong.

After upgrading again, I could notice that filtervu shows me 200MHz max value instead of 100MHz before, and time\dv decrease to 2ns instead of 4ns before. So I really think there is a chance that have worked.

I really would like to test it with a signal generator to check 3db frequency.
drsurfer:
Hello


--- Quote from: luisprata on February 09, 2016, 05:49:39 am ---I really would like to find someone who has a 2024 and could connect linux console and capture the messages.

--- End quote ---

I have a MSO 2024B and I could do it for you.  8)
Please tell me exactly where I have to attach the RS232 level converter.
I read "MPC870 U13(SMTX) and T12(SMRX) pins are routed to B23 and B25 pins on external connector", but I'm too lazy to actually find them. ;D
luisprata:
Look at expansion, you can put some small rigid wires into connector.
They are 8th and 10th positions counting as shown in figure.

Update: **** Please check voltage on TX and RX pins before connect...
drsurfer:
Luis, I did the connections according your picture.

I've verified that the markings on PCB match with your previous post, B25=RX (input) and B23=TX (output).
I've connected GND to the matching pin on the other side, A23.

No significant voltage at pins: on TX I would have expected to see 3.3V or similar.

Then I've connected the TX pin (B23) and ground to my to USB 3V3 converter;
I'm afraid to connect my converter output pin until I'm sure I'm doing right... :-[

No activity on terminal.  :(
Should I send some char to trigger the boot log start?

At what baud rate should happen the communication ? (later) Ok, I've read on your posted log 115200 bps.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod