Products > Test Equipment
MSO5000 Bode Plot Capability: Is it Good Enough? [Many tips about a 1st scope]
<< < (29/55) > >>
JeremyC:

--- Quote from: egonotto on October 04, 2022, 02:08:59 pm ---Hello,

here is a 25 MHz sine with 1Vpp generated by the AD2.


Best regards
egonotto

--- End quote ---

egonotto, FYI: You can enable sin(x)/x interpolation in the WaveForms and the "ad2_25MHz.png" will look smooth. The sin(x)/x in WaveForms is called "Smooth".

JeremyC:
I attached images with harmonics content in 10MHz and 25MHz sine waves generated by the integrated AWG.
Since the spectrum analyzer in AD2 is limited by 50MHz, the 25MHz shows only 2nd harmonic.

 
egonotto:
Hello,

thanks JeremyC.

Again the 25 MHz 1 Vpp from the AD2. The crosstalk is bad but comes from the cables. With the BNC adapter it is better and without cable it is even better but rather useless :)

Best regards
egonotto
JeremyC:
Front-end noise. The AD2 is powered from laptop and the flywire cable is disconnected.
 1. 1mV/d, time base 1ms/d
 2. 1mV/d, time base 1us/d
 3. 10mV/d, time base 1ms/d
 4. 10mV/d, time base 1us/d


JeremyC:

--- Quote from: egonotto on October 04, 2022, 05:27:31 pm ---Hello,

thanks JeremyC.

Again the 25 MHz 1 Vpp from the AD2. The crosstalk is bad but comes from the cables. With the BNC adapter it is better and without cable it is even better but rather useless :)

Best regards
egonotto

--- End quote ---

Yes, I agree the crosstalk is annoying. Well, it's $399 (I bought my on e-bay for $240, "New, open box") minilab in small, unshielded package. Still, it's very useful for me.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod