Products > Test Equipment
MSO5000 Bode Plot Capability: Is it Good Enough? [Many tips about a 1st scope]
<< < (36/55) > >>
balnazzar:
One thing that may be of interest.

The AD2 also has the 'no zoom out' issue, exactly as the Siglents and many other scopes.
Fungus:

--- Quote from: balnazzar on October 07, 2022, 11:47:44 am ---The AD2 also has the 'no zoom out' issue, exactly as the Siglents and many other scopes.

--- End quote ---

But the Siglent has no excuse, it has many megabytes of memory...
Fungus:

--- Quote from: balnazzar on October 07, 2022, 11:29:30 am ---I got the AD2 yesterday. I'm fooling around with it, so far i like it :)

I think I just need a flat cable to connect the BNC adapter to the AD2, otherwise the connector won't last long (hoping that the cable won't add too much crosstalk..).

--- End quote ---

I put some "feet" on the end of my BNC board:


There's a lot of pins so I don't think they'll break easily but it definitely flaps in the breeze without the feet.

balnazzar:

--- Quote from: Fungus on October 07, 2022, 11:58:21 am ---
--- Quote from: balnazzar on October 07, 2022, 11:47:44 am ---The AD2 also has the 'no zoom out' issue, exactly as the Siglents and many other scopes.

--- End quote ---

But the Siglent has no excuse, it has many megabytes of memory...

--- End quote ---

True :( I don't know why they implemented it in such a way. It's clearly a software-side issue, they could address it with little or no effort.


--- Quote from: Fungus on October 07, 2022, 11:58:54 am ---
Mine has some "feet" on the end of the BNC board.

There's a lot of pins so I don't think they'll break easily but it definitely flaps in the breeze without the feet.

--- End quote ---

Mine too (as well as the impedance analyzer). But there are lots of possible situations in which the connector can be stressed. Moving it around.. Inadvertedly pulling the probe upwards, etc.. I still think that one should attach a flat cable and leave it that way, always. Then you swap the accessories at the other end of the flat cable.

I'm finding ribbon cables of all sizes, except of course the 30-pin I need for the AD2.
egonotto:
Hello,

longer cables are electrical but worse. Crosstalk and bandwidth reduction 

Best regards
egonotto
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod