Products > Test Equipment

Multimeter probe caps

(1/2) > >>

SpacedCowboy:
Having just stabbed myself (right on a knuckle-joint!) with the exposed red probe below, I am thinking that getting a replacement for the missing cap for the end of the red probe (like on the black one) would be a good idea. Apparently my google-fu is not up to scratch, because I can't find anything that doesn't want to sell me an entire new probe-set.

Has anyone any idea where I can get the small grey plastic thing that stops me drawing my own blood when fiddling behind the shelving on which the multimeter is stored ? Many thanks if so :)

TimFox:
Maybe something from this catalog section?  Or one of the adjacent sections in their catalog.
https://www.mcmaster.com/products/cap-plugs/cap-type~push-on/

BillyO:
A bit of insulation stripped off some wire might do the trick until you find something better.

Miti:
Look for SMA dust caps. Some are pretty long, they could be exactly what you’re looking for.

Or search Ali for Rubber Sleeve Stopper Silicone Glue Insulating End Caps.

BeBuLamar:
How often you need the sharp tip probe? If not so often I would remove the probes and have regular probes the won't draw blood.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod