Products > Test Equipment

Multimeter spreadsheet (80 manufacturers and over 400 meters listed)

<< < (107/107)

I strongly recommend HT206D as it has 60/600A AC/DC clamp. It has no probe current, but you can short the probe with 0.1ohm then you get a 6A range with 0.1V/A drop. I got one from Aliexpress less than $30. I also have a Fluke and a Tek.
I clamped it on my Odyssey measure starting current 350A. I also use its MIN to get my battery drop voltage during start that is 7.4V, 2nd start 6.9V, my GS300 is 9V. These are best way to check for battery/starter status. As I know my Odyssey batter is weak, I charged it offline 48 hours and get better digit.

I think i noticed an error. The spreadsheet says the EEVblog Brymen 786 lacks NCV, while the Brymen 789 has it, but according to the manual, both have it?

Am I missing something and there is a difference in functionality here?

(Was about to buy a 786 from Dave and just was trying to understand what the delta was to the 789).

Well spotted. Both have it. The list will be corrected at the next edition.


[0] Message Index

[*] Previous page

There was an error while thanking
Go to full version