Products > Test Equipment
Need "flying wire" probes for small feature PCB probing?
JehTeh:
I have a collection of sensepeek probes that I really can't recommend enough. They offer passive scope probes up to 500MHz, as well as just low speed 'DMM' pogo probes, and they all work fantastic
I use them often on boards with 0.5mm QFPs and lots of 0402 components with zero issues. I have not had to solder on a test lead in ages.
Faranight:
Oh yeah! Sensepeek all the way. Gets a recommendation from me as well. I have zero regrets buying it :-+
https://easyengineering.eu/wp-content/uploads/2022/09/200126_Sensepeek39125_head-1024x1024.jpg
Nusa:
I'd just pull out my old wire wrap tool and wrap wires to square header pins. They're close enough to wire wrap pins to work, and that's what kynar wire was used for in the first place, way back when.
David Hess:
I use 30 gauge kynar insulated wire wrap wire for the same thing. Better oscilloscope probes have no difficulty grabbing it, and there are micro sized oscilloscope probes which are better yet.
Mechatrommer:
--- Quote from: Faranight on December 19, 2022, 06:24:27 am ---Oh yeah! Sensepeek all the way. Gets a recommendation from me as well. I have zero regrets buying it :-+
https://easyengineering.eu/wp-content/uploads/2022/09/200126_Sensepeek39125_head-1024x1024.jpg
--- End quote ---
of course we seldomly regret buying expensive stuffs... btw i made my own probes (2nd prototype.. those with colored rings) the grabbers can perfectly grab directly to smd components, but i dont feel like damaging them with many clip unclip and wiggles, so flying wires there are...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version