Hi,
AYK, when you probe a PCB with small chips and res/caps on it, you have to solder a "flying wire" to the 0603 resistor or whatever , and then clip the scope to that flying wire.
We do this with a twisted pair of kynar wire, ..but then find the scope cannot be connected to the stripped ends of the kynar as the kynar is too thin.......but we need it thin so we can solder the other end correctly to the small feature PCB......so therefore we solder 2cm pieces of 0.7mm tinned copper wire to the kynar ends, and then connect the scope probe "hat" and gnd clip to these 0.7mm pieces.
..However, the 0.7mm tinned copper wire pieces keep falling off.
We have thought of wrapping the kynar round the tinned copper wire, (then soldering it to the 0.7mm) and also wrapping some of the kynar insulation too.....then taping that to the tinned copper wire (or heatshrinking it), but that will mean ages spent making such probes.
Is there anything offtheshelf like this?
We searched but cant find.