Products > Test Equipment

Need help hacking DP832 for multicolour option.

<< < (36/91) > >>

mleyden:
DG1022Z -> DG1062Z successful over LAN (using same USB stick that did my DP832 -> DP832A upgrade):

>telnet 192.168.1.XXX 5555
*IDN?
Rigol Technologies,DG1022Z,DG1ZA183______,03.01.12
:PROJ:STAT MODEL,DG1062Z
*IDN?
Rigol Technologies,DG1062Z,DG1ZA183______,03.01.12

Thanks!

CustomEngineerer:

--- Quote from: 2N3055 on April 07, 2019, 11:18:18 am ---DG1000Z doesn't work over telnet.. It hangs the AWG completely (not responsive to buttons)..
Will try over USB, installing UltraSigma..

--- End quote ---

Maybe stupid question, but going to ask anyways. At least on the DP832, once you connect (or maybe once you send the first command) over telnet, the power supply locks out the buttons on the front panel. If you want to resume controlling the power supply from the front panel, you have to hit the back button first, which takes it out of remote command mode. Is it possible the DG1000Z is the same?

WhichEnt2:

--- Quote from: mleyden on April 07, 2019, 12:37:20 pm ---DG1022Z -> DG1062Z successful over LAN (using same USB stick that did my DP832 -> DP832A upgrade):

--- End quote ---
Did you perform full range sweep to check whether it is somewhat flat on the extended range?

2N3055:

--- Quote from: CustomEngineerer on April 07, 2019, 12:44:07 pm ---
--- Quote from: 2N3055 on April 07, 2019, 11:18:18 am ---DG1000Z doesn't work over telnet.. It hangs the AWG completely (not responsive to buttons)..
Will try over USB, installing UltraSigma..

--- End quote ---

Maybe stupid question, but going to ask anyways. At least on the DP832, once you connect (or maybe once you send the first command) over telnet, the power supply locks out the buttons on the front panel. If you want to resume controlling the power supply from the front panel, you have to hit the back button first, which takes it out of remote command mode. Is it possible the DG1000Z is the same?

--- End quote ---
No it is not in remote mode. It blocks both on telnet connection (no response after command) and instrument non responsive... Can't press local to get it back. Reboot needed.

It is 2016 instrument , maybe something is downlevel.. DG1022Zs are new ones, maybe have new boot/OS portion...

2N3055:

--- Quote from: WhichEnt2 on April 07, 2019, 12:47:10 pm ---
--- Quote from: mleyden on April 07, 2019, 12:37:20 pm ---DG1022Z -> DG1062Z successful over LAN (using same USB stick that did my DP832 -> DP832A upgrade):

--- End quote ---
Did you perform full range sweep to check whether it is somewhat flat on the extended range?

--- End quote ---
My DG1032Z is pretty much dead flat to 60 MHz

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod