Products > Test Equipment

Need help hacking DP832 for multicolour option.

<< < (47/91) > >>

Gandalf_Sr:

--- Quote from: PeDre on June 07, 2019, 03:21:31 pm ---
--- Quote from: Gandalf_Sr on June 07, 2019, 03:11:26 pm ---"There was an error when sending the SCPI command" and after that, the device I just tried to send the :PROJ:SET MODEL,XXXX command to is not seen in RigolBildschirmkopie after search until I cycle power.
--- End quote ---

This error is displayed if the device does not confirm that it has received the command. Unfortunately the Rigol devices do not comply with the VXI (LAN) and USBTMC standard.
In this case the command was sent correctly.

Peter

--- End quote ---
Thanks for the reply but the device is not changed to the new model?

tv84:

--- Quote from: Gandalf_Sr on June 07, 2019, 03:11:26 pm ---Any ideas?

--- End quote ---

Try linux to send the command.

_Wim_:

--- Quote from: Gandalf_Sr on June 07, 2019, 03:41:21 pm ---Thanks for the reply but the device is not changed to the new model?

--- End quote ---

For the DG1062, the command is :PROJ:STAT MODEL,DG1062Z  (not SET, but maybe both work). I seem to remember I had to put a space between model and the modelnumber :PROJ:STAT MODEL, DG1062Z

_Wim_:

--- Quote from: Gandalf_Sr on June 07, 2019, 03:11:26 pm ---Any ideas?

--- End quote ---

Are you sure you can see the contents of the USB key from the Rigol device? You can try to save a file to the key first to ensure you can correctly read the usb key (the Rigol deveices are very picky about the USB keys)

Gandalf_Sr:

--- Quote from: _Wim_ on June 07, 2019, 04:00:32 pm ---
--- Quote from: Gandalf_Sr on June 07, 2019, 03:11:26 pm ---Any ideas?

--- End quote ---

Are you sure you can see the contents of the USB key from the Rigol device? You can try to save a file to the key first to ensure you can correctly read the usb key (the Rigol deveices are very picky about the USB keys)

--- End quote ---
I tried to save a file to the USB drive on the DP832 and it worked just fine.
I tried the :PROJ:STAT MODEL, DG1062Z command via RigolBildschirmkopie and it gave the same error.

I might have suspected firmware upgrade differences but it seems unlikely I'd get the same issue on both if device itself were the problem and the DG1022Z and the DP832 are pretty recently updated (not quite the latest).

Maybe it's the USB drive.  Is there some way I can check that the keyfile.bin file is in the correct location?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod