Products > Test Equipment

Need help hacking DP832 for multicolour option.

<< < (68/91) > >>

tv84:

--- Quote from: Houseman on February 21, 2020, 02:40:39 pm ---Any hints?

--- End quote ---

riglol code has plenty of var definition problems, memory leaks and non-deallocated structures. If you don't do an overall verification of the whole code, you must have some luck in choosing the compiler and 32/64 bit architecture.

Overcoming those problems is the skill that one needs in order to earn a generated lic. :)

Houseman:
Got it! I understand. Thank You. Managing to compile the whole code and get the bin was already a long way...
Will walk anyway forward. Regards

Houseman:
THANKS MAN.
I have now an OFFICAL license... (CHINGLISH)
Does it still show to your device?

Regards


--- Quote from: tv84 on February 21, 2020, 03:11:19 pm ---
--- Quote from: Houseman on February 21, 2020, 02:40:39 pm ---Any hints?

--- End quote ---

riglol code has plenty of var definition problems, memory leaks and non-deallocated structures. If you don't do an overall verification of the whole code, you must have some luck in choosing the compiler and 32/64 bit architecture.

Overcoming those problems is the skill that one needs in order to earn a generated lic. :)

--- End quote ---

Houseman:
First of all, thanks for the great-huge work.
Have a DG1022Z riglol.upgraded to a 1062Z
Works like a charme
HOWEVER.
The Ultrastation Software recognize the unit as 1062Z but you can only draw waveforms less than 20MHz..
Attached the screenshot.
Any hints??

Thank You.
 


--- Quote from: tossu on April 06, 2019, 02:50:31 pm ---
--- Quote from: RoGeorge on April 06, 2019, 12:54:03 pm ---Anybody with the latest FW and manual IP care to check the DP832 settings please? (to check press 'Utility' -> 'IO Config' -> 'LAN')
Do you have the DNS set to 88.218.37.64 after a power cycle, like this?

--- End quote ---

I upgraded my DP832 to 1.16, and it is doing the same thing. The DNS is set to 88.218.37.64 when a "LAN connected" notification is shown. However, the value I've set is restored if I go back to the DNS settings. I noticed FW 1.14 changes the DNS as well, but it sets it to 0.0.0.0.

I took a quick look at a DG1032Z firmware I found somewhere. I think it's version 1.06. It has a very similar check for the same magic value at sector 0x78EC.

Could someone eager to hack (or brick) their DG1032Z send these commands to it, preferably via USB, and post the results here? The keyfile.bin I made for DP832 should work.

--- Code: ---:PROJ:STAT MCALTIMES,QUERY
*IDN?
:PROJ:STAT MODEL,DG1062Z
*IDN?

--- End code ---

The first command is just a sanity check. It should print CH1 = <some number>, CH2 = <some number>.

--- End quote ---

_Wim_:

--- Quote from: Houseman on February 22, 2020, 10:56:47 pm ---The Ultrastation Software recognize the unit as 1062Z but you can only draw waveforms less than 20MHz..

--- End quote ---

This is normal, see extact of datasheet below.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod