Products > Test Equipment

Need help hacking DP832 for multicolour option.

<< < (73/91) > >>

jcfoto:
I'd made two recents "print screen" of my DS2202E scope ( full options !) from DG upgraded :
Sinus 59MHz -> Very little Frequency and voltage modulation. It's correct. 5vcc
Square 15MHz -> Very ... funny square signal, is'nt it ? Correct up to 5MHz. 5vcc
For hight frequency square signals, i use µ controlers ( more efficient).

On join "print screen", scales and samples of scope may be readable.

PA0PBZ:
15, 25 and 50MHz square from an upgraded DG4062 on a MSOX3054:





edgelog:
Just an observation which slightly worries me.

After updating the DP832 from firmware 00.01.16.00.00 to 00.01.16.00.02 I also configured the analog boards by doing the HELP-HELP-M4-M2-M1 and HELP-HELP-M4-M2-M2. Interestingly, the analog version went down a tick after that.

Before upgrading, the analog version was 03.02.05.03.02.05, but after the upgrade it was 03.02.04.03.02.04. It irks me a little bit.

belzrebuth:

--- Quote from: edgelog on June 10, 2020, 11:49:38 am --- I also configured the analog boards by doing the HELP-HELP-M4-M2-M1 and HELP-HELP-M4-M2-M2.

--- End quote ---

Sorry but what's this?
This configuring of the analog boards I mean..Wheere did you find this key-pattern?
Is it mentioned in the manual?
I have a problem with my DP832 so it couldn't hurt to try it.

About your problem:
Could you try to downgrade the firmware and then redo the above?

edgelog:

--- Quote from: belzrebuth on June 10, 2020, 01:10:58 pm ---
--- Quote from: edgelog on June 10, 2020, 11:49:38 am --- I also configured the analog boards by doing the HELP-HELP-M4-M2-M1 and HELP-HELP-M4-M2-M2.

--- End quote ---

Sorry but what's this?
This configuring of the analog boards I mean..Wheere did you find this key-pattern?
Is it mentioned in the manual?
I have a problem with my DP832 so it couldn't hurt to try it.

About your problem:
Could you try to downgrade the firmware and then redo the above?

--- End quote ---

You’ll find this key sequence in earlier messages, but I think I’ve seen it in older release notes as well.

I’m not really having a problem, just a little bit confounded by the version numbers, so I’m not going to downgrade again. Not unless I run into some problem down the road.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod