Products > Test Equipment
New (toy?) DSO+LCR meter - Fnirsi DSO-TC2 (june 2022)
<< < (3/7) > >>
indman:
ARM MM32F103 RET6 - component tester
WCH CH32F103 C8T6 - oscilloscope ;)
ledtester:

--- Quote from: indman on July 24, 2022, 08:14:39 am ---ARM MM32F103 RET6 - component tester
WCH CH32F103 C8T6 - oscilloscope ;)

--- End quote ---

I couldn't tell if you were serious, but it appears you are correct.

At the 3:00 mark this Russian language video asserts that the MM32F103 is responsible for the component tester and the WCH chip for the oscilloscope:

FNIRSI DSO-TC2 - осциллограф + транзистор-тестер
https://youtu.be/PXzY-pvd7OM?t=3m

At that point there is a close-up of the PCB and you can see the triple pair of 680R and 470K resistors near the top and they are connected to the MM32F103:



I'm curious what that chip in between the two MCUs is.


indman:

--- Quote from: ledtester on August 21, 2022, 03:07:19 pm ---I couldn't tell if you were serious, but it appears you are correct.

--- End quote ---
This became clear immediately after it was possible to read the marking of the chips.Because the CH32F103 C8T6 FNIRSI is also used in other pocket oscilloscopes.


--- Quote from: ledtester on August 21, 2022, 03:07:19 pm ---I'm curious what that chip in between the two MCUs is.

--- End quote ---
RS2227-Analog switch
https://datasheet.lcsc.com/lcsc/2202251530_Jiangsu-RUNIC-Tech-RS2227XUTQK10_C783419.pdf
CChin254:
Here are the chips used on the FNIRSI Digital Oscilloscope & Transistor Tester:


(Image was from Dave Jones' Flickr account.)
snapper:
the replacement TC3 only has a 100-pin µC from which unfortunately the labeling has been removed   :rant:
But with the TC3, the designer must have run away with it. Why do you need almost 40 transistors in the measurement circuit?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod