Products > Test Equipment

New 2ch pocket DSO+SG - Zeeweii DSO2512G

<< < (106/130) > >>

RAPo:
very nice Tim.

Is this procedure valid for all soft/firmware versions of DSO2512G?

timschuerewegen:

--- Quote from: RAPo on October 27, 2023, 11:19:15 am ---Is this procedure valid for all soft/firmware versions of DSO2512G?
--- End quote ---

This specific/added feature will obviously only work in combination with my modified V1.3.0C firmware. The V1.3.0C firmware might be compatible with all PCB versions. Someone will have to try it.

TEOTEO:
hi everyone i wanted to ask if the firmware update can be done on firmware version 1.2.0 with PCB version 8.7 which should be the first release yet SIGPEAK. Or you risk destroying it ??
thanks

Aldo22:

--- Quote from: TEOTEO on October 27, 2023, 08:00:19 pm ---hi everyone i wanted to ask if the firmware update can be done on firmware version 1.2.0 with PCB version 8.7 which should be the first release yet SIGPEAK. Or you risk destroying it ??
thanks

--- End quote ---
I once asked the Zeeweii Official Store if I could upgrade V1.2.8C to an improved version. The answer was:
"Hi, we don't recommend you to upgrade it, we only have improved firmware for V1.2.9C version now. Unpredictable errors may occur after other version upgrades."

TEOTEO:
the software is fine overall, there is just a bug in the NORM trigger mode which is annoying, if it can be fixed. Since from the last posts some DIY modifications can be made, I was also thinking on a functional level.....

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod