Products > Test Equipment

New 2ch pocket DSO+SG - Zeeweii DSO2512G

<< < (109/130) > >>

timschuerewegen:
PCB V8.7  => compatible with FW V1.2.0
PCB V9.1 => compatible with FW V1.2.8B (and my modified V1.3.0C)
PCB V9.13 => compatible with FW V1.2.8B (and my modified V1.3.0C)
PCB V9.14 => compatible with FW V1.2.8C / V1.2.8C+ (and probably also V1.2.9C / V1.3.0C)
PCB V9.15 => compatible with FW V1.2.9C / V1.3.0C (and probably also V1.2.8C / V1.2.8C+)

EDIT: You also need to upgrade the FPGA firmware if you upgrade from a firmware older than V1.2.9C to V1.3.0C or else you will have AUTO issues. You can only upgrade the FPGA firmware if you are using my modified V1.3.0C firmware or if you can reprogram the SPI flash chip via either external programmer or USB FEL mode.

timschuerewegen:
For those who are not on my Discord server, here are a few screenshots to show the progress being made.

RAPo:
Top work, thanks!

Faissal:
Hello everyone!
I'm new here  :)

Can i update my scope DSO2512G?
HW: V9.1
firmware: v1.2.8B

to version like v1.2.8C or v1.2.8C+

Thanks for your help.

Faissal:

--- Quote from: timschuerewegen on November 12, 2023, 05:45:57 pm ---PCB V8.7  => compatible with FW V1.2.0
PCB V9.13 => compatible with FW V1.2.8B (and modified V1.3.0C)
PCB V9.14 => compatible with FW V1.2.8C / V1.2.8C+ (and probably also V1.2.9C / V1.3.0C)
PCB V9.15 => compatible with FW V1.2.9C / V1.3.0C (and probably also V1.2.8C / V1.2.8C+)

EDIT: You also need to upgrade the FPGA firmware if you upgrade to V1.3.0C or else you will have AUTO issues. You can only upgrade the FPGA firmware if you are using my modified V1.3.0C firmware or you can reprogram the SPI flash chip via either external programmer or USB FEL mode.

--- End quote ---

How about my PCB V9.1? is there any chance to update? :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod