Products > Test Equipment
New bench scope - Fnirsi 1014D, 7", 1GSa/s
pcprogrammer:
That makes it a problem then. The fact that the display has back-light tells us that the FPGA is doing something. Not sure if the GD32 chip in there for the knobs and buttons can block the boot up.
If you know your way around software the disassembly of the 1014D is also in the Ghidra archive in the 1013D hack repository. Maybe with the info from there you can determine why it hangs.
I gave up on reverse engineering this scope. Done the 1013D and that was educational and fun, but also frustrating.
joseph4511:
Dont want to repair if its more then firmware issue. I ll send it back while i can, thank you so much.
joseph4511:
they sent me a new motherboard which works perfect. Couplings work as they should. My old broken board has allwinner F1C100S and new one has f1c200s, could it be the issue ?
YurkshireLad:
--- Quote from: joseph4511 on April 30, 2022, 06:58:10 pm ---they sent me a new motherboard which works perfect. Couplings work as they should. My old broken board has allwinner F1C100S and new one has f1c200s, could it be the issue ?
--- End quote ---
Does the motherboard have a different revision number than the original?
joseph4511:
there s no rev. number written. Only 1014D OSC, nothing is different than old board but F1C100s
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version