Products > Test Equipment

New EEVblog BM786 Multimeter

<< < (28/133) > >>

EEVblog:

--- Quote from: Specmaster on November 17, 2020, 05:56:28 pm ---
--- Quote from: Wytnucls on November 17, 2020, 03:20:35 pm ---It is documented. REC gives you the usual Max/Min/Average values as on other multimeters.

--- End quote ---
Yes I understand that, but what I'm saying here is, that the REC is a possible workaround to the issue of autohold, unless autohold will automatically reset itself each time
--- End quote ---

AutoHold does reset itself, that's why it's called AUTOhold. Just like the original Fluke TouchHold who I believe invented it on the 70 series.

Specmaster:

--- Quote from: EEVblog on November 17, 2020, 10:25:39 pm ---
--- Quote from: Specmaster on November 17, 2020, 05:56:28 pm ---
--- Quote from: Wytnucls on November 17, 2020, 03:20:35 pm ---It is documented. REC gives you the usual Max/Min/Average values as on other multimeters.

--- End quote ---
Yes I understand that, but what I'm saying here is, that the REC is a possible workaround to the issue of autohold, unless autohold will automatically reset itself each time
--- End quote ---

AutoHold does reset itself, that's why it's called AUTOhold. Just like the original Fluke TouchHold who I believe invented it on the 70 series.

--- End quote ---
Yes, it does, I just tried the Hold function on my Fluke 27 which works perfectly.

Wytnucls:
Fuse replacement seems like a bit of a nuisance for such a recently designed multimeter:
8 screws to remove the front panel and battery compartment for access to both fuses.

EEVblog:

--- Quote from: Wytnucls on November 18, 2020, 12:33:22 pm ---Fuse replacement seems like a bit of a nuisance for such a recently designed multimeter:
8 screws to remove the front panel and battery compartment for access to both fuses.
--- End quote ---

Yes. That likely stems from design restrictions bought about by the decision to use the overmoulding to presumably look'n'feel like the Fluke 70 series.

Fungus:

--- Quote from: Wytnucls on November 18, 2020, 12:33:22 pm ---Fuse replacement seems like a bit of a nuisance

--- End quote ---

That's a good thing - teaches you to not blow fuses.  :-+

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod