Products > Test Equipment

New EEVblog BM786 Multimeter

<< < (63/133) > >>

Fungus:

--- Quote from: 2N3055 on February 14, 2021, 11:18:29 am ---If you look at that diagram, that dotted line on the left is not the fuse curve.

--- End quote ---

What's the line on the left for?

HKJ:

--- Quote from: Fungus on February 14, 2021, 12:56:46 pm ---
--- Quote from: 2N3055 on February 14, 2021, 11:18:29 am ---If you look at that diagram, that dotted line on the left is not the fuse curve.

--- End quote ---

What's the line on the left for?

--- End quote ---

I would expect it was minimum and maximum, i.e. the fuse may or may not blow in between the two curves. This also matches the table where 2.75x do not contain any values.

2N3055:

--- Quote from: Fungus on February 14, 2021, 12:56:46 pm ---
--- Quote from: 2N3055 on February 14, 2021, 11:18:29 am ---If you look at that diagram, that dotted line on the left is not the fuse curve.

--- End quote ---

What's the line on the left for?

--- End quote ---
I wouldn't know, not my diagram. I presume that is some Joule heat (current/time integral) limit...

Fungus:
Maybe it's guaranteed not to blow to the left of that line.

Wytnucls:
No. That's the minimum line for the 1A/2A fuse. 1ms to 1 hr. (4 In to 1 In).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod