Products > Test Equipment

New EEVblog BM786 Multimeter

<< < (104/133) > >>

AVGresponding:
It's worth mentioning that they are a standard size (10mm x 38mm) but odd value 11A and (400?)mA. You've a good chance of finding 10A ones at an electrical factors quite cheaply, though the mA ones are likely to still be a bit pricey but you should find them easily available from Mouser or Digikey or whatever your local electronics supplier is.

10A is probably fine as a replacement; if you're measuring stuff of that magnitude you should probably be using a clamp anyway.

joeqsmith:
Some idiot YT expert blabbing on about safety with while showing off his Fluke with some fuse from the local hardware store installed.   :palm:   

Monkeh:
That's an expensive fuse, too.

AVGresponding:

--- Quote from: joeqsmith on September 21, 2021, 05:33:53 pm ---Some idiot YT expert blabbing on about safety with while showing off his Fluke with some fuse from the local hardware store installed.   :palm:

--- End quote ---

Looks like a Cooper-Bussmann LP-CC, which is a very good, very safe fuse, but completely wrong for the application...

https://uk.rs-online.com/web/p/cartridge-fuses/8484386

If you are gonna use a non-Fluke one, at least pick one with the correct voltage ratings.   :palm:

Algoma:
The fact that the fuse is replaced alone indicates a potential past mistake already occurred (Or was tested to fault on purpose for review). 

Certainly something to check for your safety when acquiring a second hand meter, that a correct Fuse is in place.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod