Products > Test Equipment

NEW Fluke 87-VI Multimeter

<< < (9/18) > >>

zaoka:
I think its about time that Fluke makes something new that will lead industry for next 20 years as 87V did. A meter with 0% tolerance.. ESR, Component tester, fast bar graph, pp to measure AC ripple and OLED or something better, AutoV mode on diode/ohm range like Fluke 12 had to discharge capacitors if needed during troubleshooting...  ;D

Fungus:

--- Quote from: zaoka on September 19, 2024, 03:11:29 am ---I think its about time that Fluke makes something new that will lead industry for next 20 years as 87V did.

--- End quote ---

Fluke customers don't want change, they want the 87V.

They have training courses, written procedures, etc., all based around it.

Fluke bosses don't want it either, the 87V is a cash cow.

I expect they'll still be making it 1000 years from now.

dexar:
I sure do hope they keep on making it because it is at the end of the day a really really good multimeter and one you can trust. Want to do do a total redesign? Fine, but keep selling the old 87V model.

Arhigos:

--- Quote from: zaoka on September 19, 2024, 03:11:29 am ---I think its about time that Fluke makes something new that will lead industry for next 20 years as 87V did. A meter with 0% tolerance.. ESR, Component tester, fast bar graph, pp to measure AC ripple and OLED or something better, AutoV mode on diode/ohm range like Fluke 12 had to discharge capacitors if needed during troubleshooting...  ;D

--- End quote ---

I think the last time when they tried to make a multimeter with all possible bells and whistles it was a complete disaster in sales (i'm talking about 867b )

BeBuLamar:

--- Quote from: zaoka on September 19, 2024, 03:11:29 am ---I think its about time that Fluke makes something new that will lead industry for next 20 years as 87V did. A meter with 0% tolerance.. ESR, Component tester, fast bar graph, pp to measure AC ripple and OLED or something better, AutoV mode on diode/ohm range like Fluke 12 had to discharge capacitors if needed during troubleshooting...  ;D

--- End quote ---

0% tolerance is something can never be done.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod