Products > Test Equipment

New Hantek DSO2X1X models?

<< < (307/388) > >>

TheQuentincc:
Thanks for your answer, so I dismantled it a bit but it doesn't look that bad, I mean traces of flux shouldn't be an issue for a button... I'll clean that and reflow Ux IC, otherwise I don't have tools to measure the 600kHz signal... could I use the scope itself, half dismantled to check it ?
Thanks again

edit : so I reflowed all the IC, it seems a bit better but I still have the issue sometime...

unicornio:
i make a test with my hantek awg of the dso, and a wandel&golterman spm15, and my hantek 6,5 digit multimeter, at 1khz, 0dbm, and the results are perfect...;-)

unicornio:
thanks so much,

i find that the fan is 50*50 mm, so i can buy it without teardown my dso!...

so many thanks and electronics greetings from spain

DavidAlfa:
Following this, the new display arrived, fits exactly like the original and the image quality is just as good.

Leaving the AT070TN94 link for everyone:
https://www.aliexpress.com/item/32918916584.html
(It's the 5mm model)

vistorik:

--- Quote from: DavidAlfa on August 09, 2023, 02:32:46 pm ---Leaving the AT070TN94 link for everyone:
https://www.aliexpress.com/item/32918916584.html

--- End quote ---
Page Not Found  :(

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod