Products > Test Equipment

New Hantek DSO2X1X models?

<< < (311/388) > >>

aleph0:
OK!
Any chance the platform_tools zip file is corrupted?
I downloaded it both in windows and in Linux and cannot extract the restore.bat file (or the Readme_English.pdf file for that matter) from it, but many other files such as Readme_English.doc extract just fine.
I see platform_tools.zip with the following md5:

--- Code: ---$ md5sum platform-tools.zip
70280b90e88a60ff001bd984a0b3a0ae  platform-tools.zip
--- End code ---

DavidAlfa:
Indeed, it was corrupted! Something went wrong when I updated it 2 weeks ago.
Should be working now.

--- Code: ---md5  8086da8f46f5d6ae4dd18a254f4c0757

--- End code ---

aleph0:
I finally got time to flash it. Went into FEL mode, ran restore.bat, screen showed the funny colored stripes, flash finished without issues, scope rebooted and... still the same behavior. no buttons work, no signal being displayed for either of the channels, all buttons have their lights on..
this sucks big time. I guess at this point I should ask for a refund as the scope is completely useless.

Thank you very much DavidAlfa for all your help.

DavidAlfa:
Yeah, this is a real problem then!
You could try to disassemble it and reseat the ribbon cable connecting the mainboard and the front panel.
There's no warranty stickers anywhere, and it's pretty simple.

laserdyne.rd:
TRIGGER PROBLEM. (DSO2D15)
Pretty sure this is a bug.
In 'Normal' trigger mode, I hit 'Run/Stop' to STOP, but it still triggers once AFTER Run/Stop is red. It behaves almost identically to the Single Seq button.
It's pretty bad; sometimes it's hard to get that one magic capture, only to have it disappear when you disconnect the probe.
Can anyone confirm this? My setup uses x10 probe and Ch1. Not sure if it applies elsewhere.
SW 1.0.3.0.0
FW 3205

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod