Products > Test Equipment

New Hantek DSO2X1X models?

<< < (321/388) > >>

DavidAlfa:
This issue never hapened before, maybe a defective flash? I don't know.
I suggest contact Hantek with this issue, they will likely send some platform-tools version!

DavidAlfa:
I made some changes to dsoflash. Please download the latest version.

If running, power off the scope to reset everything.
Power the scope in FEL mode and run "dsoflash status", post the output.
Run "dsoflash erase", and "dsoflash status" again, is the output the same?.

This is my output:

--- Code: ---Status 1: 0x7C
SRP0    BP3     BP2     BP1     BP0     TB      WP-E    SRP1
0       1       1       1       1       1       0       0

Status 2: 0x08
OTP-L   OTP-E   SR1-L   ECC-E   BUF     RES     RES     RES
0       0       0       0       1       0       0       0

Status 3: 0x00
RES     LUT-F   ECC-1   ECC-0   P-FAIL  E-FAIL  WEL     BUSY
0       0       0       0       0       0       0       0

--- End code ---

IonutL:
The output is the same and exactly as yours, both before and after the flash erase.

DavidAlfa:
Nothing seem wrong with the flash. Did you try restoring with dsoflash already?

Another thing you can try is to download a 132MB from here:
https://pinetools.com/random-file-generator

Flash it, then read it back, then open both files in HxD and run Analysis / Compare data to see what's wrong.

Ensure to store your original backup in a safe place, NO in the same folder, you might accidentally overwrite it.

IonutL:
Yes, the restore with dsoflash gets me to the point where I started this conversation: the scope boots, but updates fail with the "error code is -2", some settings do not survive reboot, cannot save/ recall settings.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod