Products > Test Equipment

New Hantek DSO2X1X models?

<< < (337/388) > >>

Aldo22:

--- Quote from: vistorik on November 21, 2023, 02:09:15 pm ---
--- Quote from: Aldo22 on November 21, 2023, 01:53:32 pm ---
--- Quote from: vistorik on November 21, 2023, 01:24:51 pm ---David, you can get this new software version from 4pda.to/forum: https://4pda.to/forum/dl/post/29467623/dso3kb_20230906.upk.zip

--- End quote ---
My Russian is not very good, but 404 probably means "not found" there too. ;)

--- End quote ---
You do not have access to download files from this forum without registering. David has it.

--- End quote ---
OK, but the message should then read "401 Unauthorized".

DavidAlfa:
Yeah you need to be logged on to download!
Edit: Attached. It's actually 23.08.31 version.
Will update the faq/Drive tomorrow.

eospss:
My English is not good, so I used Google Translate:
I successfully modified 2c15 into 2d15. However, other problems arose during the modification process. I disassembled the device to determine if any relevant original parts were missing. However, after installing it back, I found that the CH1 reference voltage drifted greatly after the machine was cold-started. I tried to calibrate the device but the system reported error code 510d1. Just wait until the machine warms up and restart it a few times.
vbase is constantly changing, the highest is 90v, the lowest is -400mv.
CH2 is normal.
Did I break something while disassembling the device?

DavidAlfa:
Did you change FW version?

eospss:
No, I just upgraded the software to the latest one. fw is always 3202.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod