Products > Test Equipment
New Hantek DSO2X1X models?
<< < (342/388) > >>
kakas:
I have purchased a DSO02C10 from Banggood some weeks ago. It arrived with the latest software apparently. I was able to upgrade it to 2D15 with the "do_other_update" method. The dso3kb_FW3205_B205.upk did not work for me: it successfully ran, but nothing was changed. The older FW .upk-s did not work either: ran sucessfully and after restart nothing has been changed.

Thank you for the great job of DavidAlfa and all the others made it possible.
God bless you all.
DavidAlfa:
FW has nothing to do with the model.
Did you read the FAQ?

Reuploaded broken 2023.08.31 update (It downloaded a 0 byte file).
eurotips:
This year, Santa Claus was generous and gave me a DSO2C10 oscilloscope. I have already made a backup and upgrade to 2D15. I was lucky and the generator was present on the pcb. Here are the software versions it came with: Software 1.0.3.0.0(230831.00)
Hardware 003.002.001.000.000.000.000.000 Firmware 3205
On the PCB, the marking DSO2D15_V1.7 2021.1.14

The first thing I noticed is that my power supply is different than I saw on the Internet, it has a different SMPS controller. And in my case it is +7V/-7V and not +8V/-8V as before.

This is my first post on the Forum, but generally speaking, I have been working in electronics for over 30 years. Greetings to everyone.
DavidAlfa:
Yes, there's a revised PSU in latter models.
Aldo22:

--- Quote from: eurotips on December 04, 2023, 06:49:23 pm ---The first thing I noticed is that my power supply is different than I saw on the Internet, it has a different SMPS controller. And in my case it is +7V/-7V and not +8V/-8V as before.

--- End quote ---

I also have one of these PSUs and don't see any worrying noise even at 2mV/div.
A little in normal acquire mode and almost nothing in HR mode. (Nothing connected).
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod