Products > Test Equipment
New Hantek DSO2X1X models?
kakas:
I have purchased a DSO02C10 from Banggood some weeks ago. It arrived with the latest software apparently. I was able to upgrade it to 2D15 with the "do_other_update" method. The dso3kb_FW3205_B205.upk did not work for me: it successfully ran, but nothing was changed. The older FW .upk-s did not work either: ran sucessfully and after restart nothing has been changed.
Thank you for the great job of DavidAlfa and all the others made it possible.
God bless you all.
DavidAlfa:
FW has nothing to do with the model.
Did you read the FAQ?
Reuploaded broken 2023.08.31 update (It downloaded a 0 byte file).
eurotips:
This year, Santa Claus was generous and gave me a DSO2C10 oscilloscope. I have already made a backup and upgrade to 2D15. I was lucky and the generator was present on the pcb. Here are the software versions it came with: Software 1.0.3.0.0(230831.00)
Hardware 003.002.001.000.000.000.000.000 Firmware 3205
On the PCB, the marking DSO2D15_V1.7 2021.1.14
The first thing I noticed is that my power supply is different than I saw on the Internet, it has a different SMPS controller. And in my case it is +7V/-7V and not +8V/-8V as before.
This is my first post on the Forum, but generally speaking, I have been working in electronics for over 30 years. Greetings to everyone.
DavidAlfa:
Yes, there's a revised PSU in latter models.
Aldo22:
--- Quote from: eurotips on December 04, 2023, 06:49:23 pm ---The first thing I noticed is that my power supply is different than I saw on the Internet, it has a different SMPS controller. And in my case it is +7V/-7V and not +8V/-8V as before.
--- End quote ---
I also have one of these PSUs and don't see any worrying noise even at 2mV/div.
A little in normal acquire mode and almost nothing in HR mode. (Nothing connected).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version