Products > Test Equipment
New Hantek DSO2X1X models?
<< < (354/388) > >>
Aldo22:

--- Quote from: DavidAlfa on January 23, 2024, 06:37:04 pm ---Yes, it will improve a lot.

--- End quote ---

Thank you!
Do I understand you correctly that you have replaced all the encoders?
The big ones work fine for me and most of the smaller ones are acceptable.
Only V0 is really troublesome. It sometimes just changes direction depending on the rotation speed.
Unfortunately, I need it very often and for many turns, for the frequency of the AWG, FFT center, etc.
Sometimes I start the laptop just to make a setting via SCPI command.  :palm:
DavidAlfa:
The encoders are cheap, it's the shipping what bulks the costs.
V0 was unusable, trigger level did some woes.... I didn't want to open it again 2 months later, so yeah I replaced them all.
Aldo22:
Yes, the shipping costs...
The store here with halfway reasonable shipping costs only has PEC12R-4220F-S0024 in stock, i.e. the one with the 24 detents.
You said:


--- Quote from: DavidAlfa on May 24, 2023, 05:19:27 pm ---After thinking it twice, I'll avoid the mechanical steps in the small encoders, adjusting certain values require a lot of turning, dealing with a ton of clicking will make the experience even worse!

--- End quote ---

Since the original big knobs have 12 mechanical steps and are pretty tough to turn, I would like to ask you if the Bourns PEC12R with 24 detents (Which you have installed for the big knobs?) would be acceptable for the V0 too? Or are they too hard to turn?

Thank you!
DavidAlfa:
They work well. I put 24 steps everywhere, but didn't put detents on v0 and trigger, would be annoying.
Aldo22:

--- Quote from: DavidAlfa on January 24, 2024, 11:53:12 am ---They work well. I put 24 steps everywhere, but didn't put detents on v0 and trigger, would be annoying.

--- End quote ---

So you wouldn't recommend these for the V0.

Well, then I'll wait for a good opportunity for one with "Detent Option 0 = No Detents"
The other stores here charge a flat rate of more than € 20 for shipping alone.
That's too much for a $130 scope.
Maybe I'll need something else soon so that it's worth ordering there.
The price on Aliexpress is also absurd.

Thank you!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod