Products > Test Equipment
New Hantek DSO2X1X models?
<< < (355/388) > >>
DavidAlfa:
Just think: Will you enjoy a lot of brrrrrrrr when moving V0 to adjust anything? I don't think so?
Check RS-Online, here in Spain it has the best shipping rates.
Aldo22:

--- Quote from: DavidAlfa on January 24, 2024, 04:00:21 pm ---Just think: Will you enjoy a lot of brrrrrrrr when moving V0 to adjust anything? I don't think so?
Check RS-Online, here in Spain it has the best shipping rates.

--- End quote ---
Thanks for the tip! I haven't looked at this store yet.
But as far as I can see, they don't have the desired encoder either:

https://ch.rs-online.com/web/c/?searchTerm=PEC12R-4020F-S0024
DavidAlfa:
Did you read everything? I had the same problem, the solution is very simple! Just buy the 4225 and cut  ~2mm off the shaft.

--- Quote from: DavidAlfa on May 24, 2023, 05:19:27 pm ---If not being able to source them, the PEC12R-4225 (12mm shaft) will almost fit, the small caps have a depth of 12mm while the large ones have 11.2mm, it would only require trimming a bit off the shaft end.

--- End quote ---
Aldo22:

--- Quote from: DavidAlfa on January 24, 2024, 05:13:08 pm ---Did you read everything? I had the same problem, the solution is very simple! Just buy the 4225 and cut  ~2mm off the shaft.

--- End quote ---

Yes, thank you. I had seen it.
I'll probably do it that way, I was just hoping to get the exact model at a reasonable shipping price.
It does exist here at Mouser or Digikey, but the delivery costs are too high.
DavidAlfa:
It's just cutting 2mm of the shaft plastic... Why the overthinking?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod