Products > Test Equipment

New Hantek DSO2X1X models?

<< < (355/388) > >>

DavidAlfa:
Just think: Will you enjoy a lot of brrrrrrrr when moving V0 to adjust anything? I don't think so?
Check RS-Online, here in Spain it has the best shipping rates.

Aldo22:

--- Quote from: DavidAlfa on January 24, 2024, 04:00:21 pm ---Just think: Will you enjoy a lot of brrrrrrrr when moving V0 to adjust anything? I don't think so?
Check RS-Online, here in Spain it has the best shipping rates.

--- End quote ---
Thanks for the tip! I haven't looked at this store yet.
But as far as I can see, they don't have the desired encoder either:

https://ch.rs-online.com/web/c/?searchTerm=PEC12R-4020F-S0024

DavidAlfa:
Did you read everything? I had the same problem, the solution is very simple! Just buy the 4225 and cut  ~2mm off the shaft.

--- Quote from: DavidAlfa on May 24, 2023, 05:19:27 pm ---If not being able to source them, the PEC12R-4225 (12mm shaft) will almost fit, the small caps have a depth of 12mm while the large ones have 11.2mm, it would only require trimming a bit off the shaft end.

--- End quote ---

Aldo22:

--- Quote from: DavidAlfa on January 24, 2024, 05:13:08 pm ---Did you read everything? I had the same problem, the solution is very simple! Just buy the 4225 and cut  ~2mm off the shaft.

--- End quote ---

Yes, thank you. I had seen it.
I'll probably do it that way, I was just hoping to get the exact model at a reasonable shipping price.
It does exist here at Mouser or Digikey, but the delivery costs are too high.

DavidAlfa:
It's just cutting 2mm of the shaft plastic... Why the overthinking?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod