Products > Test Equipment
New Hantek DSO2X1X models?
<< < (382/388) > >>
Aldo22:

--- Quote from: OLderDan on May 11, 2024, 02:58:32 pm ---Can I link to this post with hantek support to see if that clearly simple offset calculation can be fixed in a patch.

--- End quote ---

Is there any news on this?

I took another look at it.
Under certain conditions it is hardly noticeable.
It is then still slightly shifted in the measurement, but visually it looks good.
Now I have to find out why/when this is the case...
nogo:
Hello, I bought a dso2d15 in 2021, which worked well, newer software improved its operation. But when I uploaded the last one (2024-05-07, the firmware changed to 3209), I haven't been able to calibrate since then and it says error 511d1! I loaded firmware (3202 and 3208) and older software, but nothing changed! Do you have any idea what I should do to make it good again?
DavidAlfa:
What was your original hw? Try fw 3102 and sw 24.02.02.
Everything available in the FAQ (See my signature)
nogo:
Thank you very much! It looks good, I was able to calibrate it and everything fell into place. I will test it in more detail tomorrow. Unfortunately, I don't remember the original sw anymore, I only found this forum today. Hantek didn't even answer me. Thank you!
vistorik:
DavidAlfa, I'm sorry, but where is your FAQ? I can not find it. The link to FAQ opens the 8th page but there is no FAQ.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod