Products > Test Equipment

New Hantek DSO2X1X models?

<< < (382/388) > >>

Aldo22:

--- Quote from: OLderDan on May 11, 2024, 02:58:32 pm ---Can I link to this post with hantek support to see if that clearly simple offset calculation can be fixed in a patch.

--- End quote ---

Is there any news on this?

I took another look at it.
Under certain conditions it is hardly noticeable.
It is then still slightly shifted in the measurement, but visually it looks good.
Now I have to find out why/when this is the case...

nogo:
Hello, I bought a dso2d15 in 2021, which worked well, newer software improved its operation. But when I uploaded the last one (2024-05-07, the firmware changed to 3209), I haven't been able to calibrate since then and it says error 511d1! I loaded firmware (3202 and 3208) and older software, but nothing changed! Do you have any idea what I should do to make it good again?

DavidAlfa:
What was your original hw? Try fw 3102 and sw 24.02.02.
Everything available in the FAQ (See my signature)

nogo:
Thank you very much! It looks good, I was able to calibrate it and everything fell into place. I will test it in more detail tomorrow. Unfortunately, I don't remember the original sw anymore, I only found this forum today. Hantek didn't even answer me. Thank you!

vistorik:
DavidAlfa, I'm sorry, but where is your FAQ? I can not find it. The link to FAQ opens the 8th page but there is no FAQ.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod