| Products > Test Equipment |
| New Keysight 4 Channel Scope (1200 X-Series) |
| << < (3/17) > >> |
| nctnico:
--- Quote from: Twasnow on February 12, 2019, 10:57:45 pm ---The really want the decoding (all of it, I am designing for CAN bus a lot and I2C a lot) --- End quote --- If you are really after decoding then look at the R&S RTB2000 too. Maybe outside the budget but R&S really put much thought into cramming as much information as possible on the screen. For example: if you make the decoder traces higher, the texts rotate 90 degrees when the boxes get smaller so there is more room horizontally to show packets without losing the information. I don't know whether R&S is the only one doing this but I have not seen this on other oscilloscopes. Sorry for going off-topic in this thread but Tautech is peddling Siglent as well 8) I'll stop right here. Edit: one advantage of the Keysight though is that it can decode across segments and use the list display to jump from one segment to the other. In turn I have not seen any other oscilloscopes do that. |
| TK:
--- Quote from: nctnico on February 12, 2019, 11:49:35 pm ---Edit: one advantage of the Keysight though is that it can decode across segments and use the list display to jump from one segment to the other. In turn I have not seen any other oscilloscopes do that. --- End quote --- I am not sure the Keysight 1000X series has list display for serial decoding, are you referring to 2000 / 3000 series? |
| Mr. Scram:
Do Siglents have the same hardware based processing, like decoding and the interface? I thought they don't. |
| 2N3055:
--- Quote from: Mr. Scram on February 13, 2019, 12:57:20 am ---Do Siglents have the same hardware based processing, like decoding and the interface? I thought they don't. --- End quote --- Hardware based processing is nice for speed but is crap sometimes. If you capture something, and then switch on decoding it won't decode anything. You need to recapture, because decoding works in capture time not display. With software decode you can see something and than switch on decoding, even experiment if this is this or that. Every solution has it's pros' and cons, and what is best for you depends heavily on what you do and what is your process. |
| nctnico:
--- Quote from: TK on February 13, 2019, 12:38:49 am --- --- Quote from: nctnico on February 12, 2019, 11:49:35 pm ---Edit: one advantage of the Keysight though is that it can decode across segments and use the list display to jump from one segment to the other. In turn I have not seen any other oscilloscopes do that. --- End quote --- I am not sure the Keysight 1000X series has list display for serial decoding, are you referring to 2000 / 3000 series? --- End quote --- I don't know about the 1000X series. I'd assume a scope with decoding has a list display... |
| Navigation |
| Message Index |
| Next page |
| Previous page |