New oscilloscope from Fnirsi DPOS350P

[Ivont]

this error which you will see in the picture if you look carefully

Well I don't know what the error is and I've looked closely. Is it because the generator is set to squarewave but the display of same is a sine? I only think this because the discussion is about the generator not remembering its setting, but that in itself wouldn't be too bad (lots of things seem to do that), so I can only think that it is much worse and showing you that it is doing one thing but actually doing another?

Do I get the prize? There was a prize, wasn't there? Otherwise why make it a secret that only the super-attentive will notice? You could have given a clue, or even a white-on-white spoiler if it hurt too much to just say what the problem was or what the screen is showing.

Soooooo.  Very interesting but never mind.🤔🤔🤔

[Ivont]

I have always known that the Chinese are a great nation.      There is no more powerful nation.      The only ones who produce everything.  I am glad that there are such people, such a people.

[BrianRosenthal]

If yangyao is still watching this thread, a couple of items for your next firmware update:

1.  It doesn't appear that the trigger mode is being saved in the configuration.  Set it to Normal, save, power off and reload and the trigger remains at Auto.

2.  There doesn't appear to be a way to check the installed firmware version.

Thanks!

[Ivont]

I didn't understand anything.  Very strange.  What is it about?  It's already in English, now what are you telling me to do?

[Ivont]

If yangyao is still watching this thread, a couple of items for your next firmware update:

1.  It doesn't appear that the trigger mode is being saved in the configuration.  Set it to Normal, save, power off and reload and the trigger remains at Auto.

2.  There doesn't appear to be a way to check the installed firmware version.

Thanks!

Now I understand you.  That's right.

[Ivont]

A slider can be added to accurately measure the location.  When the cursor is moved, a precision position slider should also appear.  After 1 second to hide.