Products > Test Equipment
New Rigol DS1054Z oscilloscope
tv84:
--- Quote from: alexalr on September 06, 2020, 11:16:31 am ---The changes you made to the firmware file interest me.
--- End quote ---
Here.
Long ago this stopped from being rocket science...
Supposedly you can flash my crafted FW anytime as it will flash the 00.04.04.04.03 stock file over the DS Z-E 00.06.02.00.01.
alexalr:
--- Quote from: tv84 on September 06, 2020, 11:34:40 am ---
--- Quote from: alexalr on September 06, 2020, 11:16:31 am ---The changes you made to the firmware file interest me.
--- End quote ---
Here.
Long ago this stopped from being rocket science...
Supposedly you can flash my crafted FW anytime as it will flash the 00.04.04.04.03 stock file over the DS Z-E 00.06.02.00.01.
--- End quote ---
wrote your file to USB, but the oscillograph says "USB device detected" and does not see the update. Your way didn't work. I replaced the version text in the original firmware file and changed the firmware name, only then the oscillograph restored its functionality with 4 channels. When I sewed the device with the Z-E version, there was a 2ns scan, we need to try to add this scan to the original firmware.
ebastler:
--- Quote from: alexalr on September 06, 2020, 01:04:59 pm ---[...] we need to try to add this scan to the original firmware.
--- End quote ---
„we“.
Alright, go ahead then.
tv84:
--- Quote from: alexalr on September 06, 2020, 01:04:59 pm ---wrote your file to USB, but the oscillograph says "USB device detected" and does not see the update. Your way didn't work.
--- End quote ---
Did you unzip it? :-//
alexalr:
--- Quote from: tv84 on September 06, 2020, 02:18:33 pm ---
--- Quote from: alexalr on September 06, 2020, 01:04:59 pm ---wrote your file to USB, but the oscillograph says "USB device detected" and does not see the update. Your way didn't work.
--- End quote ---
Did you unzip it? :-//
--- End quote ---
Of course I unpacked, and how else I made updates with similar files. I placed this file in a DS1000ZUpdate.GEL USB stick root. The bootloader checks the update version, which is located at 10h in the firmware file, and the version is lower than the one that is already firmware ignores. I changed the entry 00.04.04.04.03 to 00.06.02.00.01, that is, to the one that was already in the memory of the oscillograph, but he again did not accept it. I had to change the name of the firmware from DS1000ZUpdate.GEL to DS1000Z-EUpdate.GEL, only after that the oscillograph adopted the update. All 4 channels are fully operational.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version