Products > Test Equipment

New Rigol DS1054Z oscilloscope

<< < (908/966) > >>

tv84:

--- Quote from: alexalr on September 06, 2020, 03:17:53 pm ---I changed the entry 00.04.04.04.03 to 00.06.02.00.01, that is, to the one that was already in the memory of the oscillograph, but he again did not accept it. I had to change the name of the firmware from DS1000ZUpdate.GEL to DS1000Z-EUpdate.GEL, only after that the oscillograph adopted the update. All 4 channels are fully operational.

--- End quote ---

Did you do these changes in a stock FW or in my FW?

alexalr:

--- Quote from: SERJSOCHI on August 23, 2020, 07:18:51 pm ---Thank you.


--- Quote from: bitseeker on August 23, 2020, 03:19:23 am ---the values

--- End quote ---
I don't know how to move values yet. I tried to move the panel down, but then the trigger value is at the wrong level in relation to other values.

I added some changes and edited previous post. Now I love my ds1054z.

--- End quote ---
And I will completely love when I manage to add a 2ns scan

alexalr:

--- Quote from: tv84 on September 06, 2020, 03:22:55 pm ---
--- Quote from: alexalr on September 06, 2020, 03:17:53 pm ---I changed the entry 00.04.04.04.03 to 00.06.02.00.01, that is, to the one that was already in the memory of the oscillograph, but he again did not accept it. I had to change the name of the firmware from DS1000ZUpdate.GEL to DS1000Z-EUpdate.GEL, only after that the oscillograph adopted the update. All 4 channels are fully operational.

--- End quote ---

Did you do these changes in a stock FW or in my FW?

--- End quote ---
I made changes to the original firmware file 00.04.04.04.03 before you sent me your file.

tv84:

--- Quote from: alexalr on September 06, 2020, 03:33:03 pm ---I made changes to the original firmware file 00.04.04.04.03 before you sent me your file.

--- End quote ---

So that means Rigol disabled the footer verification of the header's version # in the Z-E!  :palm:

Everyone can downgrade a Z-E just by changing the version # in the file header. Let's see for how long...

alexalr:

--- Quote from: tv84 on June 16, 2020, 09:17:33 am ---Navigational Warning

Don't flash the Z-E firmware in the old DS1000Z scope!

Because it seems Rigol made an error and it's possible to flash the 1st released version in the older machine, limiting it to 2 channels.

--- End quote ---
Did you kill your oscillograph with a Z-E firmware, too?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod